26GB

General

The system has entered standby
mode.
• This is not a malfunction. The system
enters standby mode automatically in
about 30 minutes when there is no
operation or audio signal output
(page 24).
The clock or timer setting is canceled.
• The power cord is disconnected or a
power failure occurred. Set the clock
(page 13) and timer (page 22) again.
There is no sound.
• Adjust the volume.
• Check the connection of the optional
equipment, if any (page 11).
• Turn on the connected equipment.
There is severe hum or noise.
• Move the system away from sources of
noise.
• Connect the system to a different wall
outlet.
• Install a noise filter (commercially
available) to the power cord.
• Turn off surrounding electrical
equipment.
The timer does not function.
• Check the timer setting and set the
correct time (page 22).
• Cancel the Sleep Timer function
(page 22).
The remote control does not function.
• Remove the obstacles between the
remote control and the unit.
• Move the remote control closer to the
unit.
• Point the remote control at the unit’s
sensor.
• Replace the batteries (R6/size AA).
• Move the unit away from the
fluorescent light.
“CHILD” and “LOCK” appear when
you press any button on the unit.
• Set the Child Lock function to off
(page 24).

iPod/iPhone

There is no sound.
• Make sure the iPod/iPhone is connected
securely.
• Make sure the iPod/iPhone is playing
music.
• Make sure the iPod/iPhone is updated
with the latest software.
• Adjust the volume.
The sound is distorted.
• Make sure the iPod/iPhone is connected
securely.
• Turn down the volume.
• Set the “EQ” setting of the iPod/iPhone
to “Off” or “Flat”.
Unexpected track changes occur
during playback.
• Turn off the “Shake to Shuffle” function
(changing tracks by shaking the iPod/
iPhone) on the iPod/iPhone when
listening to music on the iPod/iPhone at
high volumes. If this function is
enabled, unexpected track changes may
occur due to the vibrations caused by
sound pressure from the system.
The iPod/iPhone does not function.
• If the battery of the iPod/iPhone is
empty, it may not work with this system.
In this case, recharge it with a computer,
etc. then connect it to the system.
• Quit all running applications on your
iPod or iPhone before using it with the
system. For details, refer to the
operating instructions of your iPod/
iPhone.
• Make sure the iPod/iPhone is connected
securely.
• Make sure the iPod/iPhone is updated
with the latest software.