Sony RDR-HX1000 Controlling TVs with the remote, Notes, Code number, Manufacturer, 4 Release [/1, 2 Hold down [/1, 1 Slide the TV/DVD switch to TV

Controlling TVs with the remote

You can adjust the remote’s signal to control your TV.

If you connected the recorder to an AV amplifier (receiver), you can use the supplied remote to control the AV amplifier’s (receiver’s) volume.

Notes

•Depending on the connected unit, you may not be able to control your TV or AV amplifier (receiver) with some or all of the buttons below.

•If you enter a new code number, the code number previously entered will be erased.

•When you replace the batteries of the remote, the code number may be reset to the default setting. Set the appropriate code number again.

				TV/DVD
				switch
				"/1
	1	2	3	PROG +/–
	4	5	6
Number buttons,
SET/-/--	7	8	9	2 +/–
		0
				t, TV/DVD

1 Slide the TV/DVD switch to TV.2 Hold down [/1.

3 Enter your TV’s manufacturer code (see “Code numbers of controllable TVs” below) using the number buttons.

4 Release [/1.

When the TV/DVD switch is set to TV, the remote performs the following:

[/1	Turns your TV on or off
2 (volume) +/–	Adjusts the volume of your
	TV
PROG +/–	Selects the programme
	position on your TV
(wide mode)	Switches to or from the
	wide mode of a Sony wide-
	screen TV
t (TV/video)	Switches your TV’s input
	source

Number buttons and	Selects the programme
SET, -/--*	position on your TV

*If you use the number buttons to select the TV’s programme position, press -/-- followed by the number buttons for two-digit numbers.

To operate the TV/DVD button (for SCART connections only)

The TV/DVD button switches between the recorder and the last input source selected on the TV. Point your remote at the recorder when using this button. The button works even if the TV/DVD switch is set to DVD.

When you connect the recorder to the TV via the SCART jacks, the input source for the TV is set to the recorder automatically when you start playback. To watch another source, press the TV/ DVD button to switch the TV’s input source.

Code numbers of controllable TVs

If more than one code number is listed, try entering them one at a time until you find the one that works with your TV.

Manufacturer	Code number
Sony	01 (default)
Aiwa	01 (default)
Grundig	11
Hitachi	23, 24, 72
Loewe	06, 45
Nokia	15, 16, 69, 73
Panasonic	17, 49
Philips	06, 07, 08, 23, 45, 72
Saba	12, 13, 36, 43, 74, 75
Samsung	06, 22, 23, 71, 72
Sanyo	25
Sharp	29
Telefunken	12, 13, 36, 43, 74, 75
Thomson	12, 13, 43, 74, 75
Toshiba	38
LG	06
JVC	33

20