•Use a disc that conforms with ISO9660 Level 1, Level 2 or Joliet in the expansion format.
•The disc ID3 tag is not ver. 1 nor ver. 2.
•Only up to 30 characters of ID3 tags are displayed.
•The characters that can be displayed by this system are as follows:
–Upper cases (A to Z)
–Numbers (0 to 9)
–Symbols (’< > * + ,
Other characters may not be displayed correctly.
Tuner
Severe hum or noise/stations cannot be received. (“TUNED” or “STEREO” flashes in the display.)
•Set the proper band and frequency (page 14).
•Connect the antenna properly (page 7).
•Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna.
•The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully.
•Locate the antennas as far away from the speaker cords as possible.
•Try turning off surrounding electrical equipment.
•Set “CD POWER OFF” by CD power manage function (page 15).
A stereo FM program cannot be received in stereo.•Press FM MODE repeatedly until “STEREO” appears.
Tape deckThe tape does not record or play, or there is a decrease in sound level.•The heads are dirty. Clean them (page 33).
•The record/playback heads are magnetized. Demagnetize them (page 33).
The tape does not erase completely.•The record/playback heads are magnetized. Demagnetize them (page 33).
There is excessive wow or flutter, or the sound drops out.•The capstans or pinch rollers are dirty. Clean them (page 33).
•The record/playback heads are magnetized. Demagnetize them (page 33).
The tape does not record.•No cassette is loaded. Load a cassette.
•The tab has been removed from the cassette. Cover the broken tab with adhesive tape (page 33).
•The tape has wound to the end.
If the system still does not operate properly after performing the above measures, reset the system as follows:
Use buttons on the unit for the operation.
1Disconnect the power cord.
2Reconnect the power cord.
3Press ?/1 to turn on the system.
4Press x, ILLUMINATION and DISC 1 at the same time.
The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer.
Note
You cannot reset the system to the factory settings in Power Saving Mode (page 24).