Horizontal frequency: 28–61 kHz (SDM-S53) 28–80 kHz (SDM-S73/S93)

Vertical frequency: 48–75 Hz

Consequently, the first time the monitor receives input signals that do not match one of the factory preset modes, the monitor may take a longer time than normal to display the picture on the screen. This adjustment data is automatically stored in memory so that next time, the monitor will function in the same way as when the monitor receives the signals that match one of the factory preset modes.

If you adjust the phase, pitch, and picture position manually

For some input signals, the automatic picture quality adjustment function of this monitor may not completely adjust the picture position, phase, and pitch. In this case, you can set these adjustments manually (page 12). If you set these adjustments manually, they are stored in memory as user modes and automatically recalled whenever the monitor receives the same input signals.

Note

While the automatic picture quality adjustment function is activated, only the 1 (power) switch will operate.

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the following messages appears on the screen. To solve the problem, see “Trouble symptoms and remedies” on page 18.

If “OUT OF RANGE” appears on the screen

This indicates that the input signal is not supported by the monitor’s specifications. Check the following items.

For more information about on-screen messages, see “Trouble symptoms and remedies” on page 18.

If “xxx.x kHz/xxx Hz” is displayed

This indicates that either the horizontal or vertical frequency is not supported by the monitor’s specifications.

The figures indicate the horizontal and vertical frequencies of the current input signal.

I NFORMA T I ON

OUT OF RANGE

x x x . x k H z / x x x H z

If “RESOLUTION > 1024 ⋅ 768” is displayed (SDM-S53)

This indicates that the resolution is not supported by the monitor’s specifications (1024 ⋅ 768 or less).

If “RESOLUTION > 1280 ⋅ 1024” is displayed (SDM-S73/S93)

This indicates that the resolution is not supported by the monitor’s specifications (1280 ⋅ 1024 or less).

I NFORMA T I ON

OUT OF RANGE

RESOL UT I ON > 1. 2 8 0X 1 0 2 4

If “NO INPUT SIGNAL” appears on the screen

This indicates that no signal is being input.

I NFORMA T I ON

NO I NPUT S I GNA L

GO TO POWER SAVE

“GO TO POWER SAVE”

The monitor will enter the power saving mode after about 5 seconds from the time the message is displayed.

16