Setup 3:Secure the cords and close the back cover

1Slide up the back cover.

2Remove the stand cover.

3Secure the power cord and video signal cable using the cable holder on the cabinet (SDM-S53/S73). Secure the video signal cable using the cable holder on the cabinet (SDM-S93).

4Feed the power cord and the video signal cable into the stand, and secure them using the cable holder (SDM-S53/S73).

Feed the power cord through the hole on the left of the stand and secure the power cord and video signal cable using the cable holder inside (SDM- S93).

5Replace the stand cover and then slide down the back cover.

Please be sure that cords come out through the opening at the bottom of the stand cover, for proper placement of the stand cover.

SDM-S53/S73

1

3

 

back cover

cable holder

4

2

 

stand cover

cable holder

Illustrations of monitor rear are the SDM-S53.

The same applies for the SDM-S73 model.

SDM-S93

1

3

 

back cover

cable holder

4

2

 

stand cover

cable holder

Setup 4:Turn on the monitor and computer

1Press the MAIN POWER switch located on the right side of the monitor in the direction of the [, if it is not already pressed. Make sure the 1 (power) indicator is lit in red.

Note

The monitor is factory shipped with the MAIN POWER switch set to on ([).

lights in red

MAIN POWER

2Press the 1 (power) switch on the front right of the monitor.

The 1 (power) indicator lights up in green.

lights in green

8