Home Theater Operations
Adjusting the Sound
Although this speaker system's sound quality is already adjusted. You can change the settings, as you like, for each surround mode individually. The following settings remain stored in their respective surround mode until you change them.
| DELAY TIME |
TEST TONE | S. WOOFER |
REAR | ADJUST +/– |
CENTER |
|
BALANCE L/R | RESET |
| SUPER WOOFER |
| MODE (1, 2, OFF) |
1Playback a program and choose a surround mode.
2Make the following sound adjustments according to your preference and/or the type of program you are watching.
To | press | |
|
|
|
adjust the super | S.WOOFER, | |
woofer level | then press ADJUST + or – | |
|
|
|
adjust the bass level | BASS, then press ADJUST + or – | |
|
|
|
adjust the treble level | TREBLE, then press ADJUST + or – | |
|
|
|
adjust the balance | BALANCE L or R* | |
|
|
|
*Since BALANCE L and R control sound from the front speakers, they have little effect on DOLBY SUR when the source software has a high proportion of
To restore the factory settings
Press RESET after pressing either S.WOOFER, BASS, TREBLE, or BALANCE L or R.
Using an External Center Speaker
Since this system incorporates a center speaker (see page 5), you don't have to connect a center speaker. However, it is possible to connect an active center speaker to the CENTER OUT terminal.
left front speaker | active center speaker | |
|
| INPUT |
OUT | CENTER |
|
If you make this connection, be sure to make the following adjustments for Dolby Pro Logic Surround. Connecting a center speaker lets you choose from 4 different Dolby Pro Logic Surround center modes: NORMAL, WIDE, 3 CH (3 Channel logic), or PHANTOM. Use the NORMAL or WIDE mode when center and rear speakers are connected. For details on Dolby Pro Logic Surround sound, see page 14.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SURROUND |
|
|
|
|
|
|
| CENTER MODE | |||
|
|
|
|
|
|
| |||||
1Press SURROUND on the front left speaker to choose PRO LOGIC. (“PRO LOGIC” appears in the display instead of “DOLBY SUR” when you connect an external center speaker.)
2Press CENTER MODE on the front left speaker a few times until the center mode you want appears in the display.
3Adjust the speaker volume and delay time, if necessary, by referring to page 11.
12