Sony SA-VE812ED, SA-VE815ED Hookup C (SA-VE812EDonly), Hooking up the system (continued), OUT, Tip, FRONT, Notes, SPEAKER, SPEAKER, Terminal connections

Hooking up the system (continued)

Hookup C (SA-VE812ED only)

This configuration is used when the amplifier is connected to a CD player, MD deck, cassette deck, or other audio devices.

Front (Right)Front (Left)

Ee			Ee
		Subwoofer
		L	L
			e
			E
Amplifier			E
	FRONT		e
		R	R
	R	L
	eEEe	SPEAKER	SPEAKER
		IN	OUT

Attach the front speakers to the supplied speaker stands for positioning. For details, see “Positioning the front (and rear) speakers” on page 7.

Terminal connections

loosen	e	E e
e
	E	e
E
tighten		E

Notes

•Make sure the plus (+) and the minus (–) terminals on the speakers are matched to the corresponding plus (+) and minus (–) terminals on the amplifier.

•Be sure to tighten the screws of the speaker terminals securely as loose screws may become a source of noise.

•Make sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a short-circuit.

•Do not connect the subwoofer to the amplifier’s CENTER output terminal (which is for Dolby Pro Logic or Dolby Digital (AC-3)). No bass will output from the subwoofer if you do.

•For details regarding the connections on the amplifier side, refer to the manual that was provided with your amplifier.

Tip

All striped wires are minus (–) in polarity, and should be connected to the minus (–) speaker terminals.

6GB