9US
Getting Started
About the AC power cord
The supplied AC power cord has a 3-pronged grounded plug. If
you are using 3-pronged grounded mains, the plug can be
inserted directly into the mains. However, if the socket is a 2-
pronged grounded mains, use the supplied plug adapter or a
commercially available plug adapter.
3-pronged grounded mains
2-pronged polarized mains
•When the width of the mains are a different size
Use the supplied plug adapter.
•When the width of the mains are the same size
Use a commercially available plug adapter. In this case, you
can check the polarity of the mains with a commercially
available spark-testing screwdriver. It is the pronged ground
that does not light the neon grow lamp even if you insert the
spark-testing screwdriver into the mains. Insert the blades so
that the “N pole” can be inserted to the ground on the plug.
If noise (hum) is produced
Noise may be caused by an electric potential difference on the
ground circuit.* In this case, use the supplied plug adapter and
be careful not to connect the ground lead to anything.
* Although the ground of the domestic mains is normally a
safety ground, a few electrical potential differences may be
produced, depending on the mains. Therefore, use of the
supplied 3-pronged mains lead may lessen the quality of the
audio signal or may produce humming noise.
3 to 2-prong polarized
plug adapter
N pole
Note on the output jacks
This player is equipped with a Tri-Powered D/A Converter
System and a Multi Channel Management function. The usable
output settings differ depending on the mode you select as
follows. For details, refer to the Operating Instructions.
Source Multi 2CH 5.1CH
PHONES DIGITAL
Channel OUT OUT jack
(CD) OUT
Managementjacks jacks jacks
CD
—*1a*2aa*2a*4
Super Audio CD Direct
a*2aa*2×
(2 channel) 2ch + SW
aaa ×
Super Audio CD
—*1a*3aa*3×
(Multi-channel)
*1Not available for CDs or Super Audio CDs.
*2Output through the Tri-Powered D/A Converter.
*3The same signal that is output from the ANALOG 5.1CH OUT
FRONT L/R jacks is output.
*4Only when “D. OUTPUT” is set to “ON” (page 24).
Note
Tri-Powered D/A Converter System works only for 2 channel
signals from 2 CH OUT jacks.
When the i.LINK indicator lights up
•No signal is output from all the other jacks (ANALOG 2CH
OUT jacks, ANALOG 5.1CH OUT jacks, PHONES jack,
DIGITAL (CD) OUT jacks).
•The Multi Channel Management function does not work.
zWhen you want to listen to the sound through headphones
when the i.LINK indicator lights up
Connect the headphones to the PHONES jack on the amplifier,
not on this player.