Sony SDM-M81 Click, button, (PITCH), disappear, Press the, disappears, adjustment, Press the OK button, and press the OK button, the phase as the next step, M(+)/m

Eliminating flicker or blurring (PHASE/PITCH) (Analog RGB signal only)

When the monitor receives an input signal, the automatic picture quality adjustment function of this monitor automatically adjusts the picture position, phase, and pitch, and ensures that a clear picture appears on the screen. For more information about this function, see“Automatic picture quality adjustment function” on page 17.

For some input signals, this function may not completely adjust the picture position, phase, and pitch. In this case, you can manually set these adjustments according the following instructions. If you manually set these adjustments, they are stored in memory and automatically recalled whenever the monitor receives the same input signals.

These settings may have to be repeated if you change the input signal after reconnecting your computer.

8Press the M(+)/m – buttons to select (PHASE) and press the OK button.The PHASE menu appears on the screen.9Press the M(+)/m – buttons until the horizontal stripes are at a minimum.Adjust so that the horizontal stripes are at a minimum.

,

10Click [END] on the screen to turn off the test pattern.

To reset the automatic picture quality adjustment

Select SCREEN RESET and activate it using the RESET menu. For more information on using the RESET menu, see“Resetting the adjustments

1

2

3

4

5

6

Set the resolution to 1280 ⋅ 1024 ον τηε χο∝πυτερ.			(RESET)” on page 16.
Λοαδ τηε Υτιλιτψ Δισκ.			Note
			When using digital RGB signals, you do not need to set the PHASE or
Σταρτ τηε Υτιλιτψ Δισκ ανδ δισπλαψ τηε τεστ παττερν.			PITCH.
Φορ Ωινδοωσ
Χλιχκ [Υτιλιτψ]t [Windows]/[Win UtilityAdjusting.exe].the picture position
					GB
For Macintosh			(H CENTER/V CENTER) (Analog
Click [Utility][Mac]/[Mac Utility].
Press the MENU button.			RGB signal only)
The main menu appears on the screenIf the picture. is not in the center of the screen, adjust the picture’s
			centering as follows.
PressM(+)/mthe– buttons to select		(PITCH)	These settings may have to be repeated if you change the input
and press the OK button.			signal after reconnecting your computer.
The PITCH menu appears on the screen.			1 Start the Utility Disk and display the test pattern.
Press the M(+)/m – buttons until the vertical stripes			Repeat steps 2 and 3 of “Eliminating flicker or blurring
disappear.			(PHASE/PITCH) (Analog RGB signal only).”
Adjust so that the vertical stripes disappear.			2 Press the MENU button.
			The main menu appears on the screen.
	,		3 Press the M(+)/m – buttons to select	(H
			CENTER) or (V CENTER) and press the OK
			button.
			The H CENTER or V CENTER menu appears on the screen.

7	Press the OK button.	4 Move the picture up, down, left, or right until the
		frame at the perimeter of the test pattern

The main menu appears on the screen. disappears.

If horizontal stripes are observed over the entire screen, adjust Press the M(+)/m – buttons to adjust the picture’s
the phase as the next step.	centering using the H CENTER menu for horizontal
	adjustment, or the V CENTER menu for vertical
	adjustment.

5 Click [END] on the screen to turn off the test pattern.

Note

When using digital RGB signals, you do not need to set the H CENTER or V CENTER.

13