Using Coaxial Communications, Control Cable, Enable

Connection

RS-485 communication control

Connecting to RS-485 Control Cable

		CONTROL CABLE	SPEC
BLACK	WHITE	CONTROL CABLE	SPEC
BLACK	WHITE	WHITE (TRX+)	RS-485+
(TRX-)	(TRX+)
(TRX-)	(TRX+)	BLCAK (TRX-)	RS-485-
		BLCAK (TRX-)	RS-485-

Using RS-485 communication will enable you to control the OSD menu from a SAMSUNG TECHWIN System Controller or DVR.

(1)Connection to a PC.

Connect the camera to the PC via a RS-485 converter using RS-485 and a serial cable. EX) SERIAL PORT OF THE PC(COM1) → SERIAL CABLE → RS-485 CONVERTER → RS-485

CONTROL CABLE

(2)Connection to a DVR or System Controller.

Connect the RS-485 cable to the connection ports of the DVR or System Controller.

485 Control Board Connection Port			RS-485 Control Port
	(+) CONNECTION TERMINAL		WHITE (TRX+)
	(-) CONNECTION TERMINAL		BLACK (TRX-)
* RS-485 Communication establishment initial value

Item	Camera ID	BAUD RATE	UART MODE	RET PKT
Initial value	1	9600	8-NONE-1	ENABLE

Notes

•When making a control system to control the camera, please use to the protocol(STW(SPD), PELCO-P, PELCO-D, VICON, PANASONIC, BOSCH, HONEYELL, SEC).

•When you connecting to RS-485 CONTROL TERMINAL, please peel off the outer skin inside the RS-485 CONTROL TERMINAL.

•In case of SCC-101 connection, change communication mode to『8-E-1』at『Communication

configuration』menu. (For more information, refer to SCC-101 manual.)