Primary DNS server

Type the IP address of the primary DNS server.

Secondary DNS server

Type the IP address of the secondary DNS server.

OK/Cancel

See “Buttons common to every setting menu” on page 29.

Dynamic IP address notification Tab — Notifying the IP Address

When the DHCP setting is set to On or PPPoE setting is set to On on the Network tab, you can send notification of the completion of the network settings using the SMTP or HTTP protocol.

e-Mail (SMTP) notification

Select On to send an e-Mail when the DHCP setting is completed.

SMTP server name

Type the name or IP address of the SMTP server to use for sending an e-Mail, up to 64 characters.

Authentication

Select the authentication required when you send an e- Mail.

Off: Select if no authentication is required when an e- Mail is sent.

On: When authentication is required an e-Mail is sent, select one of the authentication methods from the followings.

SMTP: Select if authentication is required when an e-Mail is sent.

POP before SMTP: Select when POP before SMTP is required when an e-Mail is sent.

Note

When you set to On, make sure to select either or both SMTP or/and POP before SMTP.

POP server name

It is necessary when the POP before SMTP is selected in Authentication.

Type the POP (receiving mail) server name up to 64 characters. Or type the IP address of the POP server. This setting is necessary when the SMTP server which sends e-Mails performs authentication using the POP user account.

User name, Password

Type the user name and Password of the user who has the mail account. This setting is necessary when the SMTP server which sends e-Mails performs authentication.

Recipient e-mail address

Type the recipient e-Mail address up to 64 characters. You can specify only one recipient e-Mail address.

Administrator e-mail address

Type the e-Mail address of the camera administrator, up to 64 characters. This is used as the reply address or the address for a system mail from the mail server.

Subject

Type the subject/title of the e-Mail up to 64 characters.

Message

Type the text of the e-Mail up to 384 characters. (A line break is equivalent to 2 characters.) You can describe the information of the acquired IP address, etc. using the special tags mentioned below.

HTTP notification

Select On to output a command to the HTTP server when the DHCP setting is completed. Using this function, you can configure a useful system, for example, to view the access log stored in the HTTP server or start an external CGI program.

URL

Specify the URL to send HTTP commands, up to 256 characters. The URL is normally composed as follows:

http://ip_address[:port]/path?parameter

ip_address: Type the IP address or host name of the host to which you want to connect.

Camera the Administrating

Configuring the Network — Network setting Menu

43