Tuner Operations
Receiving Broadcasts
This section describes various ways to tune in AM and FM broadcasts. Before tuning, be sure to connect the supplied AM and FM aerials.
POWER |
|
| TUNING | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
STEREO/MONOBAND
1Turn on the amplifier and select the TUNER mode.
2Press POWER to turn on the tuner.
3Press BAND to select FM or AM.
4Press TUNING + or
Press + for a higher frequency Press – for a lower frequency
For automatic tuning
Hold down TUNING + or – for about 1 second and release it when the frequency numbers start changing. When the tuner locates a station, it stops automatically and “TUNED” appears in the display.
To stop automatic tuning before a station is located
Press TUNING + or
For manual tuning
Press TUNING + or – repeatedly to select the frequency you desire. "TUNED" appears when a station is tuned in.
5Repeat step 4 until the desired station is received.
When an FM stereo program is noisy
When the tuner receives an FM stereo program, the STEREO indicator lights in the display window. If the stereo program is noisy, press STEREO/MONO to change the tuning mode over to MONO. This eliminates the stereo effect, but the noise will be greatly reduced.
When you tune in AM stations
Adjust the direction of the AM loop aerial for optimum reception.
Presetting Radio Stations
You can store up to 20 FM and 10 AM stations.
Number buttons
MEMORY
1Tune in the FM or AM station you wish to store.
2Press MEMORY.
“MEMORY” and the last memorized number appear in the display.
3Use the number buttons
To select | press |
|
|
5 | 5 |
|
|
10 | 0/10 |
|
|
15 | >10 /1 /5 |
|
|
20 | >10 /2 /0/10 |
|
|
The tuner stores the station at the preset number you specified.
4Repeat steps 1 through 3 to store other stations.
If “MEMORY” goes out from the display before you select the preset number
Press MEMORY again.
6EN