Operations using the remote

(STR-DA5ES only)

Two remotes are supplied with STR-DA5ES (RM-LJ305, RM-US105). For details, refer to the following pages respectively.

RM-LJ305: pages 53–74

RM-US105: pages 75–81

For the remote (RM-PP505L) supplied with STR-DA3ES, refer to the separate operating instructions.

Before you use your

remote

Inserting batteries into the remote

Insert three LR6 (size-AA) alkaline batteries with the + and – properly oriented in the battery compartment. When using the remote,

point it at the remote sensor on the receiver.

]

 

}

]

 

 

 

}

 

}

 

]

 

 

 

 

Tip

Under normal conditions, the batteries should last for about 3 months. When the remote no longer operates the receiver, replace all the batteries with new ones.

Notes

Do not leave the remote in an extremely hot or humid place.

Do not use a new battery with old ones.

Do not mix the alkaline batteries and other kinds of batteries. This remote is designed for use with the alkaline batteries only.

Do not expose the remote sensor of the receiver to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Understanding the 2 way remote system

This remote operates under a 2 way remote system. With the two way remote system, the component responds to signals sent from the remote by sending additional signals (information about the status of the component, text data, etc.) back to the remote. Thus, operations are performed as a result of communication between the remote and the component.

Remote Component

When using a home entertainment system comprised of several components compatible with the 2 way remote system, please restrict 2 way remote system operation to a single component. Normally, turn off the 2 way remote system on all components except the receiver.

If you would like to turn off the receiver’s

2 way remote system, set “2-way remote” using the SET UP button (page 50).

The COMMAND MODE

If the receiver’s COMMAND MODE and the remote’s COMMAND MODE do not match, transmission is not possible between the remote and the receiver. If you have not changed the COMMAND MODE of the remote and the receiver after purchase, it is not necessary to set the COMMAND MODE. For details, see page 73.

continued

using Operations remote the

53