No sound or only a very low-level sound is heard from the surround speakers.

,Make sure the sound field function is on (press

SOUND FIELD MODE).

,Select the appropriate center mode (see pages 25–27).

,Adjust the speaker volume (see page 18).

,Make sure the surround speaker size parameter is set to either SMALL or LARGE (see page 16).

No sound is heard from the sub woofer.

,Make sure the sub woofer is set to YES (see page 17).

,Check that 2CH mode has not been selected (see page 27).

Recording cannot be done.

,Check that the components are connected correctly.

,Select the source component with a FUNCTION button.

,When recording from a digital component, make sure the input mode is set to ANALOG (see page 23) before recording with a component connected to the analog MD/TAPE terminals.

Radio stations cannot be tuned in.

,Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary.

,The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

,Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning) (see pages 36 and 45).

,No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (see page 37).

,Press DISPLAY so that the frequency appears in the display.

The surround effect cannot be obtained.

,Make sure the sound field function is on (press

SOUND FIELD MODE).

“PCM--kHz” appears on the display.

,The sampling frequency is more than 48 kHz. Change the input player setting to 48 kHz.

Nothing appears on the display.

,When the display turns off immediately after the receiver is turned on, press DIMMER to change the display mode.

No picture or an unclear picture appears on the TV screen or monitor.

,Select the appropriate function on the receiver.

,Set your TV to the appropriate input mode.

,Move your TV away from the audio components.

The remote does not function.

,Point the remote at the remote sensor g on the receiver.

,Remove any obstacles in the path between the remote and the receiver.

,Replace both batteries in the remote with new ones, if they are weak.

,Make sure you select the correct function on the remote.

,If the remote is set to operate the TV only, use the remote to select a source or component other than TV before operating the receiver or other component.

Reference sections for clearing the

receiver’s memory

To clear

See

All memorized settings

page 14

 

 

Customized sound fields

page 32

 

 

Information Additional

43