40GB
D:\NORM'S JOB\SONY HA\SO0109\STR-DH520\4263361111_GB\GB05BAS_STR-DH520-
U2.fm
masterpage: Left
STR-DH520
4-263-361-11(1)
You can enter the frequency of a station
directly by using the numeric buttons.
1Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2Press D.TUNING.
3Hold down SHIFT, then press
the numeric buttons to enter
the frequency.
Example 1: FM 102.50 MHz
• USA and Canada models only:
Select 1 b 0 b 2 b 5
• Other models:
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
Tip
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning to
an AM station.
4Press .
If you cannot tune to a station
Make sure you have entered the right
frequency. Try repeating steps 2 to 4. If you
still cannot tune to a station, the frequency
may not be in use in your area.
(USA and Canada models only)
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
receiver.
1Press ?/1 to turn off the
receiver.
2While holding down TUNING
MODE, press ?/1.
3Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
Tuning to a station directly
(Direct Tuning)
Changing the AM tuning scale
?/1
TUNING MODE