VPCSB Series Hard Disk Drive
Replacement Instructions
IMPORTANT!
PLEASE READ BEFORE YOU START
These easy instructions will guide you through the Hard Drive replacement process.
Before you begin, place your notebook computer on a clean or covered surface to avoid damage to the computer's case.*
Follow the ESD (Electrostatic Discharge) damage prevention instructions:
oHold parts by the edges, away from exposed circuitry when possible. o Do not walk around excessively as this promotes static
Before you begin, remove any jewelry you may be wearing to prevent scratches to the surface of your notebook computer.*
The appearance of the electronic components shown in the illustrations may differ from the components shipped. This slight difference does not affect the accuracy of these instructions.
*Sony is not responsible for damage caused by incorrect handling of the notebook computer.
Prepare the Computer
CAUTION: Make sure the
Computer is turned off, the lid is closed, and the AC Adapter is disconnected. Failure to do so can result in damage to the Computer.
Place the Computer upside down on a protected surface with the front edge facing you.
NOTE: If your unit is configured with an Extended Battery Pack, it must be
removed before beginning this procedure.
Extended Battery Pack Removal
1)Slide the “LOCK” battery tab up to the unlock position.
2)Slide the “RELEASE” battery tab to the Right and hold.
3)Rotate the battery up to remove.
Battery Pack Removal
Step 1. Using the enclosed magnetic screwdriver, remove the two (2)
screws securing the Hard Drive/Battery Door.
Put the screws aside to
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE
P/N 989202617 | Rev. B | 1/4 |
