BMaintenance

Replacing the Lamp

The lamp used as a light source is a consumable product. Replace this lamp with a new one in the following cases.

•When the lamp has burnt out or dims

•“Please replace the Lamp and clean the Filter.” appears on the screen.

•The LAMP/COVER indicator flashes in red. (Repetition rate of 3 flashes)

The lamp life varies depending on conditions of use.

Use an LMP-C200 Projector Lamp as the replacement lamp.

Use of lamps other than the LMP-C200 may cause damage to the projector.

Note

If the lamp breaks, consult with qualified Sony personnel for replacing the lamp and internal checking.

1 Turn off the projector, and disconnect the AC power cord from the AC outlet.

Note

When replacing the lamp after using the projector, wait at least an hour for the lamp to cool.

2 Open the lamp cover by loosening the three screws with a Phillips screwdriver.

Note

If you work with the projector hung on the ceiling, hold the lamp cover so it does not fall when you release the screws.

OET

MRERS2-

C32

 

 

OI

UAD

NI

ODEI

 

 

 

 

 

 

 

 

 

 

 

 

 

 

O

V

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DVEI

 

ODE

VIS

 

 

 

 

 

 

 

 

UTB

NPI

 

 

 

 

 

 

O

DIU

AUT

 

 

 

 

 

 

B

RG

 

 

 

 

 

 

UPT

O

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OR

NTI

OM

 

 

 

 

 

 

 

IOD

AU AUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GB

R

 

 

CORK

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

TPU

INN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WET

3 Place your fingers under the lamp cover and pull it up to remove the lamp cover.

4 Loosen the three screws on the lamp unit with the Phillips screwdriver (a), hold the knob (b), then pull out the lamp unit.

Note

Do not allow any metal objects, flammable objects, etc. into the lamp replacement slot.

5 Insert the new lamp all the way in until it is securely in place (a). Tighten the three screws (b).

46 Replacing the Lamp