72

The ON/STANDBY or LAMP/COVER indicator lights up or flashes if there is any

trouble with your projector.

When a warning indicator other than the above starts flashing, and the sy mptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
Warning Indicators
Symptom Cause and Remedy
LAMP/COVER flashes in
red. (A repetition rate of 2
flashes)
cClose the lamp cover securely, then tighten the screws securely.
(1 page 76)
cClose the filter holder securely. (1 page 77)
LAMP/COVER flashes in
red. (A repetition rate of 3
flashes)
cThe lamp has reached the end of its useful lifespan. Replac e the
lamp. (1 page 75)
cThe lamp has reached a high temperature. Wait until the lamp
cools, and then turn on the power again.
ON/STANDBY flashes in
red. (A repetition rate of 4
flashes)
cThe fan is broken. Consult with qualified Sony personnel.
ON/STANDBY flashes in
red. (A repetition rate of 2
flashes)
cThe internal temperature is unusually high. Check to ensure that
if nothing is blocking the ventilation holes or whether or not the
projector is being used at high altitudes.
ON/STANDBY flashes in
red. (A repetition rate of 6
flashes)
cPress the I/1 (ON/STANDBY) switch to turn on the projector.
If the power is not turned on, disconnect the AC power cord,
then confirm the ON/STANDBY lamp is turned off. After about
10 seconds, reconnect the AC power cord and turn on the power
again. If the indicators still light up, the electrical system has a
problem. Consult with qualified Sony personnel.
Note
ON/STANDBY indicator
LAMP/COVER indicator