Sony VPL-PX32 Connecting with a VCR/15k RGB/ Component Equipment

Connecting / Selecting the Menu Language

Notes

•As the projector recognizes the USB mouse when the computer is connected to the USB connector, do not connect anything to the MOUSE connector.

•Your computer may not start correctly when connected to the projector via the USB cable. In this case, disconnect the USB cable, restart the computer, then connect the computer to the projector using the USB cable.

•This projector is not guaranteed for suspend, standby mode. When you use the projector in suspend, standby mode, disconnect the projector from the USB port on the computer.

•Operations are not guaranteed for all the recommended computer environments.

Connecting with a VCR/15k RGB/ Component Equipment

This section describes how to connect the projector with a VCR, external active speakers, and 15k RGB/ component equipment.

Also refer to the instruction manuals of the equipment to be connected.

When making connections, be sure to:

•turn off all equipment before making any connections.

•use the proper cables for each connection.

•insert the plugs of the cables properly; plugs that are not fully inserted often generate noise. When pulling out a cable, be sure to pull it out from the plug, not the cable itself.

Right side

REMOTE	CONTROL S	VIDEO IN
	IN			L	R
RS-232C		S VIDEO	VIDEO	(MONO)
	PLUG IN POWER			AUDIO
OUTPUT		INPUT B
MONITOR	AUDIO	RGB		AUDIO	MOUSE
INPUT A
	DIGITAL
	RGB RGB
	5BNC	RGB		AUDIO	MOUSE
USB
DIGITAL RGB	R/R-Y/PR	G/Y B/B-Y/PBSYNC/HD			VD

S-Video cable	Audio/video
(not supplied)	cable
	(not supplied)
to S video	to audio/video
output	outputs
Active speakers	VCR

Right side

DIGITAL

RGB RGB
5BNC
REMOTE	CONTROL S	VIDEO IN
	IN			L	R
RS-232C		S VIDEO	VIDEO	(MONO)
	PLUG IN POWER			AUDIO
OUTPUT		INPUT B
MONITOR	AUDIO	RGB		AUDIO	MOUSE
INPUT A
	DIGITAL
	RGB RGB
	5BNC	RGB		AUDIO	MOUSE
USB
DIGITAL RGB	R/R-Y/PR	G/Y B/B-Y/PBSYNC/HD			VD

BNC Cable	Stereo audio
(not supplied)	connecting cable
	(not supplied)

to RGB/	to
component	audio
output	output

15k RGB/Component equipment

Notes

•Set the aspect ratio using ASPECT in the INPUT SETTING menu according to the input signal.

•To connect a 15k RGB/Component equipment, select the COMPUTER/COMPONENT/DTV YPBPR/DTV GBR in the INPUT-A in the SET SETTING menu according to the input signal.

•Use the composite sync signal when you input the external sync signal from 15k RGB/component equipment.

Connecting to a HDTV 1035/60i

Since the screen ratio of a high definition image is 16:9 and 576 lines are displayed in the vertical direction, the image displayed is not a high- definition image.

18 (GB)