POWER SAVING

When set to ON, the projector goes into the power saving mode if no signal is input for 10 minutes.

SIRCS RECEIVER

Selects the remote control detectors (SIRCS receiver) on the front and rear of the projector.

FRONT & REAR: Activates both the front and rear detectors.

FRONT: Activates the front detector only.

REAR: Activates the rear detector only.

The INSTALL SETTING Menu

The INSTALL SETTING menu is used for changing the settings of the projector.

INSTALL SETTING

INPUT-A

 

KEYSTONE MEM: ON

DIGIT KEYSTONE: 0

INSTALLATION: CEILING-FRONT

LAMP MODE: STANDARD

LAMP TIMER: 234h

Operation

1. Select an item

Use the M or m key to select the item, then press the

,or ENTER key.

2.Adjust an item

•When changing the adjustment level:

To increase the number, press the M or , key. To decrease the number, press the m or < key. Press the ENTER key to restore the original screen.

•When changing the setting:

Press the M or m key to change the setting.

Press the ENTER or < key to restore the original screen.

The SET SETTING Menu/The INSTALL SETTING Menu

KEYSTONE MEM

ON: DIGIT KEYSTONE setting is stored.

The data is retrieved when the projector power is turned on. The setting will remain the same every time.

OFF: DIGIT KEYSTONE is reset to 0 when the power is turned on next time.

DIGIT KEYSTONE

Corrects the trapezoid caused by the projection angle. If the base edge is longer, set a negative value; if the upper edge is longer, set a positive value to square the image.

INSTALLATION

Sets to reverse the picture horizontally or vertically.

FLOOR-FRONT:The picture is not reversed.

CEILING-FRONT: The picture is reversed horizontally and vertically.

FLOOR-REAR:The picture is reversed horizontally.

CEILING-REAR:The picture is reversed vertically.

Note

In case of using a mirror, be careful of installation since the picture may be reversed.

LAMP MODE

Sets the lamp brightness in the projection. STANDARD: Illuminates with normal brightness. LOW: Reduces fan noise and power consumption.

Compared with the STANDARD setting, the brightness of an image projecting under the LOW setting will be low.

If the LAMP MODE is set to LOW, the next time the power is turned on, the lamp will use the STANDARD setting for the first minute, and then go to LOW.

LAMP TIMER

Indicates how long the lamp has been turned on.

Note

This only displays the time. You cannot alter the display.

27 (GB)