10Press the following keys on the control panel in the following order for less than in five seconds each: LIGHT, ?, /, ENTER.
33 (EN)
Turn the adjuster inward and push it back.
Close the lamp cover and tighten the screws.
6
7
8 Turn the projector back over.
9 Connect the power cord and turn the projector to the standby mode.
5 Insert the new lamp all the way in until it is securely in place. Tighten the screw. Fold down the handle.
Notes
• Be careful not to touch the glass surface of the lamp.
• The power will not turn on if the lamp is not secured properly.
Loosen the screw on the lamp unit with the Philips screwdriver. Pull out the lamp unit by the handle.
4

Maintenance

Replacing the Lamp

When it is time to replace the lamp, replace the lamp promptly with a new LMP-600 Projector Lamp.

When replacing the lamp after using the projector

Turn off the projector, then unplug the power cord. Wait for at least an hour for the lamp to cool.

Note

The lamp will still be very hot after turning off the power. Wait until the lamp has cooled completely before replacing.

1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so it is upside down.

Note

Be careful not to topple over the projector after turning it over.

2 Pull out the adjuster by pressing the adjuster button and turn it outward.

3 Open the lamp cover by loosening two screws with the Philips screwdriver (supplied with the LMP- 600 Projector Lamp).

For safety reasons, do not loosen the other screws.

Maintenance