11
Connections and Preparations
This section describes how to install the projector and screen, how to connect the
equipment from which you want to project the picture , etc.
Unpacking
Check the carton to make sure it contains the following items:
Inserting the batteries into the remote control
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
When you dispose of the battery, you must obey the law in the relative area or country.
Connections and Preparations• Remote control (1) and
Size AA (R6) manganese batteries (2)
• AC power cord (1)
• Lens cap (1)
When you have purchased the projector,
the lens cap is put onto the lens.
Remove this lens cap when you use the
projector.
• USB charging AC power adaptor (1)
• Operating Instructions (this manual)
For VPL-HW30AES, the following items
are also contained.
• 3D glasses (2)
• USB charging cable (1)
• Pouch for the 3D glasses (2)
• 3D Sync Transmitter (1)
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may
cause a short circuit and may generate heat.
Push and slide to open.