65
Others
On-screen displayRemote control
The picture is not clear. cAdjust the focus. (1 page 23)
cCondensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
The picture flickers. cFor pictures from a computer, activate “APA” and adjust the
current input signal.
cAdjust “Phase” for “AdjustSignal” in the Screen menu
properly. (1 page 52)
The color of characters or
the picture is not
appropriate.
cSelect the desired color registration in “Panel Alignment” of
Installation menu (1 page 59).
Image is left on the screen.
(image retention)
cWhen High contrast non-moving images are displayed for a
long period of time, there may be some image retention on the
screen. This is only a temporary condition. Turning off the
power for a while will eliminate the retained image.
Symptom Cause and Remedy
Symptom Cause and Remedy
On-screen display does not
appear.
cSet “Status” in the Setup menu to “On.” (1 page 53)
cCheck if the ON/STANDBY indicator shoul d light in green. The
ON/STANDBY indicator flashes while the projector is starting
up.
Avoid using the projector until the indicator light up in green.
The model name does not
disappear from the screen.
Or else, the demo mode is
displayed continuously.
cThe display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Input terminals do not
appear.
cSet “Auto Input Search” in the Function menu to “Off”. (1
page 57)
Symptom Cause and Remedy
The remote control does
not work.
cBatteries could be weak. Replace them with new batteries.
(1 page 11)
cInsert the batteries with the correct polarities. (1 page 11)
cIf there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
cConfirm the position of the remote control detector on the
projector. (1 page 8)
cIf the 3D Sync Transmitter is pointed to the remote control
detector on the projector, the remote function may be impeded.