EN

Precautions

Before operating the unit for the first time or after replacing the car battery, press the reset button with a ball-point pen etc., and then start operating the unit.

Reset button

If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before switching on.

If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse.

If no sound comes from the speakers of a

2-speaker system, set the fader control to the centre position.

If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer.

Notes on Cassettes

Cassette care

Do not touch the tape surface of a cassette, as any dirt or dust will contaminate the heads.

Keep cassettes away from equipment with built-in magnets such as speakers and amplifiers, as erasure or distortion on the recorded tape could occur.

Do not expose cassettes to direct sunlight, extremely cold temperatures or moisture.

When the tape is played back for a long period, the cassette shell may become warm because of the built-in power amplifier. However, this is not a sign of a malfunction.

Cassettes longer than 90 minutes

The use of cassettes longer than 90 minutes is not recommended except for long continuous play. The tapes used for these cassettes are very thin and tend to be stretched easily. Frequent playing and stopping of these tapes may cause them to be pulled into the cassette deck mechanism.

Detaching and Attaching the Front Panel

The front panel of this unit can be detached in

Detaching the Front Panel

Before detaching the front panel, be sure to press the OFF button first. Then press the RELEASE button to release the front panel. Detach the panel by pulling it towards you as illustrated.

RELEASE button

Be sure not to drop the panel when detaching it from the unit.

Attaching the Front Panel

Apply the right hand side of the front panel to the unit by attaching part A of the front panel to part B of the unit as illustrated and push until it clicks.

A

B

Notes

Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down.

Do not press the front panel hard against the unit when attaching it to the unit. It can easily be attached by pressing it lightly against the unit.

When you carry the front panel with you, put it in the supplied front panel case.

Do not press hard or give excessive pressure to the display windows of the front panel.

Before removing the front panel, be sure to turn the power off. However, if you press the RELEASE button to detach the panel while the unit is still turned on, the power will be automatically turned off in order to protect the speakers from being damaged.

Do not expose the front panel to direct sunlight, heat sources such as hot air ducts or leave it in a humid place. Never leave it on the dashboard etc. of a car parked in direct sunlight where there may be a considerable rise in temperature inside the car.

Caution alarm

If you turn the ignition key to the OFF position without removing the front panel, the caution alarm will be activated and a beep tone will be heard for a few seconds (only when the POWER SELECT switch is set to the A

4 order to prevent the unit from being stolen.

position).

Actual total number:

Sony XR-6600RDS (E,F,G,I) 3-856-008-11(1)

 

 

Page 4
Image 4
Sony XR-6600RDS operating instructions Precautions, Detaching and Attaching the Front Panel