Troubleshooting guide
The following checklist will assist in the correction of most problems you may encounter with your unit.
Before going through the checklist below, refer to the operating procedures.
General
Problem | Cause/Solution |
No sound. | • Adjust the volume with (+). |
| • Set the fader control to the center position for |
| systems. |
Indications do not appear on | Remove the front panel and clean the connectors. See “Cleaning |
the display. | the Connectors” in “Maintenance” for details. |
No beep tone. | • An optional power amplifier is connected to the LINE OUT |
| and you are not using the |
| • The beep tone is attenuated. |
Tape playback
Problem | Cause/Solution |
Playback sound is distorted. | Contamination of the tape head. nClean the head. |
The AMS does not operate | • There is noise in the space between tracks. |
correctly. | • A blank space is too short (less than four seconds). |
| • + on (SEEK/AMS) is pressed immediately before the |
| following track. |
| • = on (SEEK/AMS) is pressed immediately after the track |
| starts. |
| • A long pause, or a passage of low frequencies or very low |
| sound level is treated as a blank space. |
Radio reception
Problem | Cause/Solution |
Preset tuning is not possible. | • Store the correct frequency. |
| • The broadcast is too weak. |
Automatic tuning is not possible. | The broadcast is too weak. nUse manual tuning. |
If the
EN
Information Additional
15