FM/AM Cassette
Car Stereo
Installation/Connections
Installation/Connexions
XR-CA630X
Sony Corporation © 2002 Printed in Thailand
2
A
AUDIO OUT REAR
B | BUS AUDIO IN |
| BUS CONTROL IN |
| BUS AUDIO IN |
*
Source selector
Sélecteur de source
BUS CONTROL IN
* not supplied non fourni
1
1 2 3
⋅ 4 | ⋅ 2 |
Cautions
•This unit is designed for negative ground 12 V DC operation only.
•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing).
•Before making connections, turn the car ignition off to avoid short circuits.
•Connect the yellow and red power input leads only after all other leads have been connected.
•Run all ground wires to a common ground
point.
•Be sure to insulate any loose unconnected wires with electrical tape for safety.
Connection example (2)
Notes (2-A)
•Be sure to connect the ground cord before connecting the amplifier.
•If you connect an optional power amplifier and do not use the
Tip (2-B- )
For connecting two or more CD/MD changers, the source selector
45
Notes on the power supply cord (yellow)
•When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.
•When no car circuits are rated high enough, connect the unit directly to the battery.
Parts Iist (1)
Connection diagram (3)
1To a metal surface of the car
First connect the black ground lead, then connect the yellow and red power input leads.
2 To the power antenna control lead or power |
supply lead of antenna booster amplifier |
Notes |
•It is not necessary to connect this lead if |
there is no power antenna or antenna |
booster, or with a |
telescopic antenna. |
•When your car has a |
Equipment used in illustrations (not supplied) Appareils utilisés dans les illustrations (non fournis)
Front speaker
Haut-parleur avant
Rear speaker
Haut-parleur arrière
CD/MD changer
Changeur de CD/MD
Rotary commander RM-X4S Satellite de commande RM-X4S
The numbers in the list are keyed to those in the instructions.
CautionHandle the bracket 1 carefully to avoid injuring your fingers.
1
antenna in the rear/side glass, see “Notes on |
the control and power supply leads.” |
3To AMP REMOTE IN of an optional power amplifier
This connection is only for amplifiers. Connecting any other system may damage the unit.
4 To the +12 V power terminal which is |
energized in the accessory position of the |
ignition key switch |
Notes |
•If there is no accessory position, connect to |
the +12 V power (battery) terminal which is |
energised at all times. |
Be sure to connect the black ground lead to |
it first. |
•When your car has a |
antenna in the rear/side glass, see “Notes on |
Power amplifier Amplificateur de puissance
the control and power supply leads.”
5To the +12 V power terminal which is energised at all times
Be sure to connect the black ground lead to it first.