•AAC, which stands for Advanced Audio Coding, is a music file compression format standard. It compresses audio CD data to approximately 1/11* of its original size.
•AAC tag is 126 characters.
•When naming an AAC file, be sure to add the file extension “.m4a” to the file name.
•During playback or
*only for 128 kbps
Note on AAC
Playback of a
If you have any questions or problems concerning your unit that are not covered in this manual, consult your nearest Sony dealer.
Fuse replacement |
| |
When replacing the fuse, be |
| |
sure to use one matching the |
| |
amperage rating stated on the |
| |
original fuse. If the fuse blows, |
| |
check the power connection and |
| |
replace the fuse. If the fuse |
| |
blows again after replacement, |
| |
there may be an internal |
| |
malfunction. In such a case, | Fuse (10 A) | |
consult your nearest Sony | ||
| ||
dealer. |
|
The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 5) and clean the connectors with a cotton swab. Do not apply too much force. Otherwise, the connectors may be damaged.
Maintenance
Replacing the lithium battery of the card remote commanderUnder normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion.
+ side up
Main unit | Back of the front |
| panel |
Notes
•For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch.
•Never touch the connectors directly with your fingers or with any metal device.
2 c 1
Notes on the lithium battery
•Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.
•Wipe the battery with a dry cloth to assure a good contact.
•Be sure to observe the correct polarity when installing the battery.
•Do not hold the battery with metallic tweezers, otherwise a
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in fire.
Removing the unit
1Remove the protection collar.1Detach the front panel (page 5).
2Pinch both edges of the protection collar, then pull it out.
x
14