SoundCraft D-Mix 500 manual Phono Plugs, XLRs

Connections

Phono Plugs

The phono plug inputs are all unbalanced.

The phono inputs are as follows:

CD1 Left, CD1 Right, CD2 Left CD2 Right, CD3 Left, CD3 Right CD4 Left, CD4

Gnd/Screen Signal Right, Vinyl1 Left, Vinyl1 Right, Vinyl2 Left, Vinyl2 Right, Vinyl3 Left, Vinyl3 Right,Input C Left, Input C Right, Monitor Left and Monitor Right.

The vinyl inputs have RIAA equalisers for turntables.

			Outputs
			XLRs
			The left and right main outputs are on 3-pole male XLR connectors, wired as shown
			on the left. They are balanced outputs, allowing long cable runs to balanced amplifiers
			or other equipment. If the amplifier (or other equipment) which you are using has an
1. Screen			unbalanced input, you should wire the output from the D-MIX500 as shown in the
			’Balanced To Unbalanced’ diagram below.
	3.	Cold
		(signal -ve)
2.		Hot
		(signal +ve)

Balanced

Output

Balanced To Balanced

Signal +

D-MIX 500
Balanced Output
Screen	Signal -	Screen not connected
		at external device end
Chassis Earth

Mains Earth

External Device

Input

		Signal +	Balanced To Unbalanced
			Input
D-MIX 500
Balanced Output
		Screen	Signal -
	Chassis Earth		Experience has shown that sometimes it is better
			not to connect screen at external device end
Mains Earth

External Device

Input

2.10 D-MIX500 Installation