(Continued From page 13)
INTERNAL
The REFERENCE amplifiers are fused with
and will void fbe warranfy~
Amplifier Fuse Values
Amplifier | Amplifier Fuse | Battery Fuse / |
|
| Circuit Breaker |
|
|
|
REFERENCE414s | (2) 25 amp automotive | 60 amp |
|
|
|
REFERENCE&l& | (2) 30 amp automotive | 80 amp |
|
|
|
REMOTE TURN-ON
Connect the “Remote” to the
SIGNAL CABLE
Use a
SPEAKER CABLE
The REFERENCE amps will accept up to 8 gauge speaker cable. Use a high quality, flexible,
WIRING DIAGRAM
14
4 INSTALLATION STEP 4 I.
II
INSTALLATION AND MOUNTING
1.AMPLIFIER LOCA T/ON
The REFERENCE amplifiers employ highly efficient circuitry and a unique Chassisink’” design to maintain lower operating temperatures. Additional cooling may be required if the amplifier is located in a tightly donfined area or when driving especially low impedance loads at extremely high levels.
When mounting the amplifier, it should be securely mounted to either a panel in the vehicle or an amp board or rack that is securely mounted to the vehicle. The mounting location should be either in the passenger compartment or in the trunk of the vehicle, away from moisture, stray or moving objects, and major electrical components. TO provide adequate ventilation, mount the amplifier so that there are at least two inches of freely circulating air above and to the sides of it.
2.SWITCHES
Set the Coherent
“.
7 MOUNTING THE AMPLIFIER
a. Using the amplifier as a template. mark the mounting surface. b. Remove the amplifier and drill the holes.
c. Mount the amplifier to the surface using the provided hardware.
4.WIRING
a.Run and connect the audio signal and remote
b.Carefully run the positive cable from the amplifier to a fuse or circuit breaker within 18” of the battery
c.Connect the fuse or circuit breaker to the battery Leave the circuit breaker off or the fuse out until everything is bolted down.
d.Secure the ground cable to a solid chassis ground on the vehicle. It may be necessary to sand paint down to raw metal for a good connection.
e.Double check each and every connection!
g.
spark when connecting the
Please see the comment on page 11 forinformabon
about connecting power and gmond wires to your amplifier.
5. POWER UP
Power up the system and look at the red High Power LED: there may be a 2
15