![Key to Callouts](/images/new-backgrounds/10540/1054013x1.webp)
Key to Callouts
1.Fault LED - Indicates a blown fuse.
2.High Power LED - Indicates amplifier power on in "High Power" mode.
3.High Current LED - Indicates amplifier power on in "High Current" mode.
4.Main Fuse - Main power supply fuse.
5.+12V - Connected to a fuse or circuit breaker, then to the battery's positive post.
6.GND - Main ground connection. Bolt to a clean chassis ground in the vehicle.
7.REM - Remote
8.Speaker Output Connections - Mono subwoofer channel.
9.LSE.Q - Frequency and Q adjustments.
10.Low Pass Crossover Adjustment Pot - Subwoofer channel; crossover frequency setting for the internal low pass filter.
11.Input Level - Subwoofer channel level control.
12.Inputs - Right and left channel RCA inputs for the subwoofer channel.
13.Speaker Output Connections - Channels 1 & 2.
14.Crossover Adjustment Pots - Channels 1 & 2 crossover frequency setting for the internal high pass filter in
15.Input Level - Channels 1 & 2 level control.
16.Inputs - Right and left channel RCA inputs for channels 1 & 2.
17.Speaker Output Connections - Channel 3 & 4.
18.High Pass Crossover Adjustment Pot - Channels 3 & 4 crossover frequency setting for the internal high pass filter in
19.Input Level - Channels 3 & 4 level control.
20.Inputs - Right and left channel RCA inputs for channels 3 & 4.
21.Subwoofer Channel Crossover Switch - Select LOW PASS for use with the internal crossover, or BYPASS for use with an external crossover.
22.Subwoofer Channel Input Select - Selectable inputs from internal (from channels 1 - 4) or external (from Subwoofer local RCA inputs).
23.Coherent Stereo™/Bridge Mono Switch - Channels 1 & 2; Select "Bridge" for bridged mono operation (use right channel input). Select "Stereo" for coherent stereo operation.
24.Channels 1 & 2 and 3 & 4 Bandpass Range Crossover Switch -
25.
26.Channels 1 & 2 Crossover Switch - Select "HIGH PASS" for use with the internal crossover, or "FULL RANGE" for use with an external crossover.
27.Coherent Stereo™/Bridge Mono Switch - Channels 3 & 4; Select "Bridge" for bridged mono operation (use right channel input). Select "Stereo" for coherent stereo operation.
28.
29.Channels 3 & 4 Crossover Switch - Select "HIGH PASS" for use with the internal crossover, or "FULL RANGE" for use with an external crossover in
30.Channels 3 & 4 Input Select - Selectable inputs from internal (from channels 1 & 2) or external (from channel 3 & 4 local RCA inputs) in
31.Rear Fill
32.High Power / High Current Switch - Subwoofer channel only.
7