7. LED indicatior
POWER [GREEN]
PROTECT
[RED]
POWER : This GREEN LED will illuminate when the amplifier is turned“ON”. If it fails to illuminate check the power connections to the amplifier and fuses.
PROTECT : The amplifier protection circuitry will disable the amplifier if input overload, short circuit or extremely high temperature conditions are detected. when the protection mode is in operation
the red LED indicator on the side panel will be illuminated the amplifier has gone into a
If you observe that the protection LED is lit, please check the system carefully to determine what has caused the protection circuit to engage. the amplifier can be reset by turning the remote power off and then on again. If the amplifier shut down due to a thermal overload condition. please allow it to cool down before restarting. If the amplifier shut down of an input overload or short circuit .be sure to repair these conditions before attempting to power up the amplifier again.
8.Gnd[Chassis ground)
GNDGND
To avoid unwanted ignition noise caused by ground loops. It is essential that the amplifier be grounded to a clean, bare, metal surface of the vehicles chassis.
It is not recommended to use seat or seat belt bolts..
8
