Southbend GFS35, GFS45, GFS65 C

OPERATOR’S MANUAL 1182026 REV 2PAGE 17

CLEANING

Southbend equipment is constructed with the best qualit y materials and is designed to provide durable

service when properly maintained. To expect the best perform ance, your equipment m ust be maintained in

good condition and cleaned daily. Naturally, the frequency and extent of cleaning depends on the amount

and degree of usage.

Following daily and more extensive periodic maintenance procedures will incr e as e th e l if e of your equ ipm ent.

Climatic conditions (e.g., salt air) may result in the need for more thorough and m ore frequent cleaning in

order to keep equipment performing at optimal leve ls.

! WARNING: BURN HAZARD

If necessary to move the fryer for cleaning, etc., drain oil f irst to avoid death or serious injury.

NOTICE

Adequate restraining means must be attached to rear of ap pliance when installed. Installation must

conform to local codes as applicable.

! WARNING

If disconnection of the restraint is necessary to move the app liance for cleaning, etc., reconnect it

when the appliance is moved to it originally installed position.

! WARNING

For an appliance equipped with casters, the installation s hal l be m ade with a c onnec tor that com plies

with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for

Moveable Gas Appliances, CAN/CGA-6.16, and a quick-disconnec t device that complies with the

Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect

Devices for Use with Gas Fuel, CAN1-6.9. Adequate means must be provided to limit the movement

of the appliance without depending on the connector and the quick-disconnect device or its

associated piping to limit the appliance movement.

1. Turn combination gas valve knob to “PI LOT” position.

2. Place suitable container under the dr ain and drain the frypot completely.

3. Remove the basket support frame and flus h out any sediment remaining in the frypot with a little hot o il.

4. Wipe off the basket support frame and the inside of the frypot with a clean cloth.

! CAUTION

SOME AREAS OF THE FRYPOT MAY BE HOT!