Manuals / Spalding / Fitness & Sports / Fitness Equipment

Spalding M88724C1 manual IMPORTANT! WAIT A MINIMUM OF 72 HOURS BEFORE GOING ON, Note Orientation

Models: M88724C1

1 20

Page 7

	5.	Insert ground tube assembly (2) into cement as shown. Move assembly around to release any air
	5.	pockets in cement, then rest mounting plate on cement drainage hill. Apply some pressure to level

		mounting plate on top of drainage hill. Level mounting plate and square with playing surface. Clean off
		any excess cement on mounting plate at this time and place washers (24) on mounting bolts (19).

IMPORTANT!

NOTE ORIENTATION

Front of mounting plate (2) must be parallel with playing surface.

PLAYING SURFACE

IMPORTANT!

Check leveling of mounting plate several times with carpenter’s level while concrete is curing.

24	24
	24
	24

PLAYING SURFACE

IMPORTANT!: WAIT A MINIMUM OF 72 HOURS BEFORE GOING ON

TO NEXT STEP. CONCRETE MUST CURE. ALLOW ADDITIONAL TIME

FOR COLD, WET OR HUMID WEATHER.

08/06

ID# M88724C1

Page 7

Image 7

Spalding M88724C1 IMPORTANT! WAIT A MINIMUM OF 72 HOURS BEFORE GOING ON, For Cold, Wet Or Humid Weather, Note Orientation

Contents

Customer Service Center High End Residential In-Ground Basketball System Owners ManualWrite Model Number From Box Here Adult Assembly RequiredREQUIRED TOOLS AND MATERIALS SAFETY INSTRUCTIONSDescription PARTS LISTHARDWARE IDENTIFIER NUTS, WASHERS & SPACERS HARDWARE IDENTIFIER BOLTS & SCREWSHARDWARE IDENTIFIER OTHER-NOT ACTUAL SIZE CONTACT UTILITIES BEFORE DIGGING 24 61 cm48 121.9 cm PLAYING SURFACEand build drainage hill 4. Insert rebar 10 through holes in ground tube assembly 2 as shownSIDEVIEW Fill hole with concrete. Tamp down concrete to release air pocketsNOTE ORIENTATION IMPORTANT! WAIT A MINIMUM OF 72 HOURS BEFORE GOING ONTO NEXT STEP. CONCRETE MUST CURE. ALLOW ADDITIONAL TIME FOR COLD, WET OR HUMID WEATHER08/06 Insert bushings 19 into areasshown ID# M88724C1SCRAP WOOD NOT INCLUDED PLAYING SURFACEPLAYING SURFACE Completed Assembly ID# M88724C1 While still in forward position, attach both upperand lower yokes 17 & 18 to pole as shown 08/06ID# M88724C1 Attach elevator adjustment 12 toTHREE CAPABLE ADULTS REQUIRED FOR THIS PROCEDURE. FAILURE lower yokeID# M88724C1 Attach elevator adjustment 12 to pole bracketTHREE CAPABLE ADULTS REQUIRED FOR THIS PROCEDURE. FAILURE 08/06Page Rim Assembly Refer To Instructions Included With Rim Hardware For Rim AssemblyFor rim assembly, see instructions included with rim Set-up For Right Side Set-up For Left SideNOTE ORIENTATION OF HEIGHT INDICATORS THREE CAPABLE ADULTS REQUIRED FOR THIS remove cotter pin 9, and pull out pin 8. This will allow the After pole has been secured to anchor plate 2 loosen nut10 feet 3.05 m What is Not Covered By This Warranty LIMITED LIFETIME WARRANTY