Page 2
5.Add insulation. If the area in the ceiling is not already insulated, add an adequate amount insulation material to loosely cover the back of the speaker. If the insulation material used is faced with foil or paper, position the foil or paper away from the speaker.
DT8Eazy6Zero Owner’s Manual
Diagram 2
SPEAKER INSTALLATION
The unique integral four foot mounting system incorporated into your AIM DT speaker allows for a quick installation by following these easy steps.
1.Remove the grille. It may be necessary to push one or two of the mount- ing screws, and its attached foot, towards the baffle and against the inside
surface of the grille to force the grille out of its retaining groove.
2. Attach the speaker cable (observing the proper polarity with your amplifier,
+ to + and - to
3.Make sure the mounting feet are turned inward to clear the opening,
and insert the speaker into the ceiling. Position the speaker into the hole. | Diagram 3 | |||||
Note: The flange of the speaker is designed to flex and conform to any |
|
|
|
|
|
|
small imperfections in the ceiling’s surface. Tighten the four screws on the |
|
|
|
|
|
|
front of the baffle only enough to make the flange become snug against |
|
|
|
|
|
|
the ceiling. As you tighten the screws, the feet will automatically flip into |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |
an outward position thereby clamping the drywall between the feet and |
|
|
|
|
|
|
the flange. (See Diagram 3) |
|
|
|
|
|
|
CAUTION: Over tightening may warp the baffle, crack the ceiling, cause |
|
|
|
|
|
|
the flange to distort, and make the grille difficult to install. |
|
|
|
|
|
|
4. Push the grille firmly into the slot in the speaker baffle.
SPEAKER ADJUSTMENT
Adjusting the Pivoting Tweeters |
|
Once the woofer is positioned, further refinement can be made by pointing |
|
the tweeter towards the listener. Gently pivot the tweeter to point it in the |
|
desired direction (See Diagram 4). | Diagram 4 |
|
PAINTING THE SPEAKER
If you plan to paint your speaker, we recommend that it be done prior to installation. If you plan to paint your speaker sometime in the future, it is best to remove it by simply reversing the steps for “Speaker Installation” listed above. If it is necessary to paint the speaker while it is still in the ceiling, the paint mask provided in the carton must be installed in place of the grille while the flange is being painted with the ceiling. The grille can also be painted, however, great care should be taken not to clog the holes as this will greatly reduce the sound quality of the speaker. SpeakerCraft recommends only light spray painting using 5 parts thinning agent to 1 part paint. Do not paint the grille while it is attached to the speaker.
Pivot the Tweeter by gently pushing on the sides