Speco Technologies CVCM6DC Preparation Connections Camera Adjustment, Camera Mounting

Mirror Finish Color Dome Camera CVCM6DC Installation Instructions

1 Preparation 3 Connections

4 Camera Adjustment

Remove Dome Cover

1.Gently pull the inner liner away from the dome cover.

2.Carefully turn the dome cover counterclockwise

to unlock and pull it free from the housing, then set both aside.

Note - Observe Polarity

This is a 12V DC camera – to avoid damage please observe polarity.

2

Camera Mounting

(Wall or Ceiling Mount)

1.Remove EZ Mount Plate from bottom of camera by turning counterclockwise.

2.Determine if the connection wires will exit from the bottom or side of the base.

3.If wires are going through the side, carefully remove the wire clearance tab on the side of the base.

4.Mark holes for mount position as required.

5.Attach plate to the mounting surface using anchors and screws supplied.

6.Feed the connectors into the wire hole and align holes in camera base with EZ mount plate studs.

7.Slip base over studs, gently press base against the mounting surface and rotate until the base locks in place.

8.If not using EZ Mount Plate, slip base over screws, press base against the mounting surface and rotate until the base locks in place. Tighten screws until base is firmly held but do not over tighten.

Note: Depending on the material of your mounting surface, you may require different screws and anchors than those supplied.

Connect Wiring

1.Attach BNC connector from camera to a BNC(male) connector on your video cable.

2.IF using a plug-in power supply with attached connector, verify that the center pin is the plus (+) wire and the outer shell is the negative

(-) wire.

3.IF extending power wire from a remote power supply, verify polarity on feed from power supply. Connect positive (+) wire to red wire from pigtail supplied and attach negative (-) wire to black wire from pigtail. Verify that the center pin of pigtail connector is positive (+) before connecting to the camera.

4.Connect to power supply.

Use these adjustments to align the camera position to obtain the image desired.

5

Replace Dome Cover

1.Use a soft, lint free cloth to wipe the dome cover and remove finger prints.

2.The dome cover may be replaced with or without the liner.

3.If lighting is coming from behind the camera, use the dome liner to hide the camera position.

4.Before inserting the liner note the position of the camera lens so the lens will be placed at the opening of the liner when the dome is locked in.

5.Align the dome cover tabs with the

slots in the base, gently press the cover into the slots and rotate clockwise until it is secure and the dome liner opening is aligned with the camera lens.

05.30.08