AEG F89078VI-M user manual Installation Instructions, Connecting to the water tap

EN INSTALLATION INSTRUCTIONS

5.2.1.1 Connecting to the water tap

Connect the inlet hose to a threaded ¾” gas cold water tap, fitting the supplied filter (ref. A fig. 5-06). Firmly secure the hose by tightening the relative ring nut with your hands (ref. B fig. 5-06); finish by tightening another ¼ turn using a pair of plumbing pliers. For models fitted with ACQUASTOP (ref. C fig. 5-06) the filter is already present in the threaded ring nut.

The dishwasher can be filled with water at a temperature of less than 60°C (140°F).

If the appliance is filled with hot water, washing times will be reduced by about 20 minutes, but efficiency will be slightly impaired. Make the connection to the domestic hot water tap using the same methods described for connecting the appliance to the cold water tap.

•Recommended temperature: 49°C (120°F), max. 60°C (140°F).

•Recommended water pressure: 0.5 - 9 bar (7 -130 PSI). If the pressure is too high, fit a pressure reducer.

A rubber hose connected to a sink spray may burst if installed on the same pipes feeding the dishwasher. If your sink is fitted with this accessory, re- move the hose and plug the hole.

Fig. 5-06

18 Rev 0.0