AEG F89078VI-M Installation Instructions, Connecting to a waste disposal unit with an air gap

EN INSTALLATION INSTRUCTIONS

Connecting to a waste disposal unit with an air gap

MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR ON WHICH THE DISHWASHER WILL BE INSTALLED.

1.Remove the cover of the waste disposal unit (ref. A fig. 5-12).

2.Connect the dishwasher drain hose (ref. B fig. 5-12) to the air gap (ref. C fig. 5-12) using the wide spring clamp (ref. D fig. 5-12); if necessary, cut the end of the dishwasher drain hose (ref. E fig. 5-12) (do not cut the corrugated section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”) screw clamp*.

3.To connect the air gap (ref. C fig. 5-12) to the waste disposal unit inlet (ref. F fig. 5-12), use a rubber union* (ref. G fig. 5-12) with spring or screw clamps* (ref. H

fig. 5-12).

* Available from any plumbing stockist

C
		A
D	H
	G	H
		E
	B
		Fig. 5-12

22 Rev 0.0