Specifications
Working Radius: | 1 m - 200 m (3 ft - 650 ft) | ||
(Laser dependent): |
|
|
|
Laser Detection Height: | 102 mm | (4“) |
|
Numeric Readout Height: | 76 mm | (3“) |
|
Accuracy (Dead band): |
|
|
|
Fine | 1.0 mm | 0.05 in | 1/16 in |
Medium | 5.0 mm | 0.20 in | 1/4 in |
Calibration | 0.1 mm | 0.01 in | 1/64 in |
Reception Angle: | ± 45° minimum |
| |
Detectable Spectrum: | 610 nm ... 900 nm |
| |
Beeper Volumes: | Loud = 100+ dBA |
| |
| Low = 65 dBA |
| |
Power Supply: | 2 x 1.5 Volt “AA” batteries | ||
Battery Life: | 70+ hours |
|
|
Automatic Shut Off: | 30 min |
|
|
Environmental: | Waterproof, Dustproof to IP67 | ||
Weight without clamp: | 371 g (13.1 oz.) |
| |
Dimensions without clamp: | 168.0 x 76.0 x 36.0 mm | ||
| (6.6” x 3.0” x 1.4”) |
| |
Operating Temperature: | |||
Storage Temperature: | |||
*Specifications subject to change without notice.
Warranty
Trimble warrants the HL450 to be free of defects in material and workmanship for a period of three years. (3 year limited, 2 years free exchange, 3rd year a fee is charged.) Trimble or its authorized service center will repair or replace, at its option, any defective part, or the entire product, for which notice has been given during the warranty period. If required, travel and per diem expenses to and from the place where repairs are made will be charged to the customer at the prevailing rates. Customers should send the product to Trimble Navigation Ltd. or the nearest authorized service center for warranty repairs or exchange, freight prepaid. Any evidence of negligent, abnormal use, accident, or any attempt to repair the product by other than
HL450 Laserometer
User Guide
www.trimble.com
3
2 |
|
|
| 4 |
| ||||
|
|
|
EMC Declaration of Conformity
This receiver has been tested and found to comply with the limits for a Class B digital device for radio noise for digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Com- munication, and is pursuant to part 15 of the Federal Communication Commission (FCC) rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This receiver generates radio frequency. If it’s not used in accordance with the instructions, it may cause harmful interference to radio or televi- sion reception. Such interference can be determined by turning the re- ceiver off and on. You are encouraged to try eliminating the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the laser and the receiver. For more information, consult your dealer or an experience radio/television technician.
CAUTION: Changes or modifications to the receiver that are not ex- pressly approved by Trimble could void authority to use the equipment.
Declaration of Conformity
Application of Council Directive(s): | 89/336/EEC |
Manufacturer’s Name: | Trimble Navigation Ltd. |
Manufacturer’s Address: | 5475 Kellenburger Road |
| Dayton, Ohio |
European Representative Address: | Trimble GmbH Am Prime Parc 11 |
| 65479 Raunheim, Germany |
Model Number: | HL450 |
Conformance to Directive(s): | EC Directive 89/336/EEC using |
| EN55022 and |
Equipment Type/Environment: | ITE/residential, commercial |
| & light industrial |
Product Standards: | Product meets the limit B and |
| methods of EN55022 |
| Product meets the levels and |
| methods of IEC |
| 4 kV contact IEC |
| 26 to 1000 MHz 80%, @ 1 kHz |
12
Notice to Our European Union Customers
For product recycling instructions and more information, please go to: www.trimble.com/environment/summary.html
Recycling in Europe
To recycle Trimble WEEE, call: +31 497 53 2430, and
ask for the “WEEE associate,” or
Mail a request for recycling instructions to:
Trimble Europe BV c/o Menlo Worldwide Logistics Meerheide 45 5521 DZ Eersel, NL
5
6
7
1
11 |
|
|
|
|
|
|
10 |
|
|
|
|
| 13 |
9 |
|
|
| |||
|
|
|
|
|
| |
|
|
|
|
|
| |
8 |
|
|
|
|
|
|
|
|
|
|
| ||
Trimble Construction Division
5475 Kellenburger Road
Dayton, Ohio
U.S.A.
www.trimble.com | N324 |
Front view | Rear view | ||
1. | Keypad - Power, Accuracy, Units & Volume switches. | 8. | Battery Door & Latch for two “AA” batteries. |
2. | Beeper output - Fast, solid & slow audible signal. | 9. | Marking Notch (3.15 in / 80.0 mm from top). |
3. | Bubble Vial - aids in keeping HL450 level. | 10. | Captive Screw Thread |
4. | 11. | Clamp Guides - Dimples align rod clamp. | |
| strobe lights. | 12. | Serial Number / ID Label. |
5. | SuperCell Reception Window - 4.0 in / 102 mm of height. | 13. | Rear LCD - repeats indications of front LCD. |
6.Front LCD - Displays elevation, settings and status.
7.
© 2009, Trimble Navigation Limited. All rights reserved. Reorder PN
