Installing the Batteries
1.Open the battery door using a coin or similar pry device to release the battery door tab.
2.Insert two AA batteries noting the plus (+) and minus
3.Close the battery door. Push down until it “clicks” into the locked position.
Action
Turn power ON/OFF
Display
Remarks
Initialization:
1.Test of LCD and beeper
2.CAL: Calibration (3 sec.)
3.Unit is ready for use.
Battery Status
Press to turn power ON. Press and hold for 2 seconds to turn power OFF.
1
2
(Do not power up the unit in a laser beam or strobe. If detected, the unit will display “E200” and revert to the previous
Full - | Half - | Outline - | Flashing - |
Batteries | Initial | Approx. | Change |
OK | Warning | 30 Minutes | Batteries |
|
| Remaining |
|
Rod Clamp
Select accuracy
Press once to display current setting; push again to scroll through options.
3
Accuracy in mm:
1.0 5.0
calibration.)
The selected unit of measure determines the displayed deadband (accuracy).
The current accuracy is stored in memory and will be retained when the unit is turned off or when batteries are replaced.
1
5
2
4
3
1. | Captive Rod Clamp Screw - attaches to the back of detector. |
2. | Alignment Points (2) - help secure and align rod clamp. |
3. | Clamping Screw Knob - secures clamp to rods by moving the traveling jaw. |
Select beeper volume
(No symbol)
Beeper Beeper Beeper
Loud Low Off
Press once to change current setting (A beep confirms the selected volume.)
The current beeper volume is stored in memory and will be retained when the unit is turned off or when bat- teries are replaced.
| Clockwise tightens; Counterclockwise loosens. |
4. | Reference Bar - top of bar is aligned with |
5. | Traveling Jaw - moving jaw grips tightly to rods. |
Select units of measure
mm - in - frac - ft | The current unit of measure is stored in |
| memory and will be retained when the unit |
| is turned off or when batteries are replaced. |
Press once to display current setting, additional pushes to scroll through options.
