SpectraLink 1728, 1738, 1738EX 8.1 REPORTING/DIALER (ENABLE/DISABLE), 8.2 REPORT CODES

8.1 REPORTING/DIALER (ENABLE/DISABLE)

Section [135]: Dialer Options

Option [3] OFF = Reporting/Dialer Disabled (default)

Option [3] ON = Reporting/Dialer Enabled

8.2 REPORT CODES

A report code is a 1- or 2-digit hexadecimal value consisting of digits from 1 to F. Each section from [160] to [213]

represents a set of up to four specific events and each of these events can be programmed with a separate 1- or 2-

digit report code.

Only the Ademco Slow, Silent Knight, Sescoa and Pager Formats support 1-digit report codes. To

program a 1-digit report code, press the [FORCE] key followed by the desired hexadecimal digit or

vice versa.

When a specific event occurs, the control panel will attempt to transmit the programmed report code to the central

station. The method of report code transmission is defined by the Reporting Formats (see page36) and the Event

Call Direction (see page 38). These two items define how and where the report codes are transmitted. If you are

using the Ademco Contact ID “All Codes” format, sections [160] to [213] do not have to be programmed. For more

information, refer to Reporting Formats (see page36) . The following sub-sections provide a brief description of the

events that the control panel can report.

Sections [160] to [171]

A report code can be programmed for each of the 48 User Access Codes. When using an access code to

arm a partition, the control panel can send the appropriate report code to the central station, identifying

which access code was used to arm the partition.

Sections [172] and [173]

Whenever the system is armed using one of the special arming features listed below, the control panel can

send the appropriate report code to the central station identifying how the system was armed.

Section [172]

•TIMED AUTO-ARMING: A partition has armed itself at the programmed time (see page28).

•LATE TO CLOSE: Reports every day at the time specified by the Auto-Arm Timer (see page28).

•NO MOVEMENT: A partition has armed itself after the programmed period without movement (see No

Movement Arming on page28).

•PARTIAL ARMING: A partition was Stay, Instant or Force Armed or armed with Bypassed zones.

Section [173]

•ONE-TOUCH ARMING: A partition was armed using a One-touch Arming feature (see page29).

•REMOTE ARMING: A partition was armed using the Winload software.

•KEYSWITCH ARMING: A partition was armed using a keyswitch (see page22)

• Future use

Sections [174] to [185]

A report code can be programmed for each of the 48 User Access Codes. Whenever an access code is

used to disarm an armed partition or a partition in alarm, the control panel can send the appropriate report

code to the central station, identifying which access code was used to disarm the partition.

The Disarming and the Special Disarming report codes can be transmitted every time a partition is

disarmed or only when a partition is disarmed after an alarm (see Disarming Reporting Options on

page 40).