PRELIMINARY OPERATING CHECKS

1.Remove or open all panels and inspect accessible bolts, nuts, screws, terminals and fittings for security.

2.Check belt tension, adjust if necessary (refer to Adjustment Section).

3.Energize electrical circuit to tumbler circuit breaker and turn on tumbler disconnect switch.

4.Turn on gas supply at manual gas shut off valve in gas supply line (gas models only). Handle of gas shut off valve should be parallel with gas supply line when in “ON” position.

5.Press and hold in Push-to-Start Button for approximately three (3) seconds. Release button and open cylinder door. Cylinder should stop rotating within seven (7) seconds after door is opened 3" (7.5 cm) plus or minus 1/4" (0.635 cm). If cylinder does not stop rotating, adjust cylinder door interlock (refer to Adjustment Section).

6.Load tumbler with clothes or clean rags.

7.Start tumbler and check burner flame, adjust gas inlet shutter if necessary (refer to Adjustment Section).

8.Check air flow switch operation by opening lint panel. Heating system should shut off when lint panel is opened approximately 1-1/2"

(3.81 cm). Adjust if necessary (refer to Adjustment Section).

9.Turn off tumbler.

10.Check air flow switch operation by opening lint panel. Heating systems should shut off when lint panel is opened approximately 6" (15.24 cm) with a full load.

FINAL OPERATING CHECKS

Manual Dual Timer Tumbler

1.Set temperature selector to HIGH and set drying and cool down selectors to their maximum settings.

2.Press and hold in Push-to-Start Button for approximately three (3) seconds. Motor will start, heat system will turn on, drying indicator will light and drying selector will rotate counterclockwise.

3.When drying selector reaches zero (0) heat system will shut off, drying indicator will turn off, cooling indicator will light and cooling selector will rotate counterclockwise.

4.When cooling selector reaches zero (0) motor will stop and cooling indicator will turn off indicating drying cycle is finished.

Coin Operated Tumbler

1.Set temperature selector to HIGH.

2.Insert required amount of coins.

3.Press and hold in Push-to-Start Button for approximately three (3) seconds. Motor will start and heat system will turn on.

4.Near end of cycle a preset 2 1/2 minute cool down cycle will start.

5.When metered time expires, motor will stop indicating drying cycle is finished.

Electronic Control Tumbler

Tumbler comes equipped with Electronic Control. Electronic Control gives owner a variety of programming options. To learn how to use Electronic Control, consult supplemental manual.

M412616

51