IMPORTANT

∙PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING YOUR NEW SPENDOR LOUDSPEAKERS

∙DO NOT DRILL ANY HOLES OR FIX ANY SCREWS CLOSE TO ANY AC MAINS OR OTHER ELECTRICAL CABLES

∙DO NOT DRILL ANY HOLES OR FIX ANY SCREWS CLOSE TO ANY PIPES OR CONDUITS

∙IF YOU ARE UNSURE ABOUT ANY ASPECT OF THE INSTALLATION CONSULT YOUR SPENDOR DEALER OR A QUALIFIED PROFESSIONAL BEFORE PROCEEDING

∙PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING YOUR NEW SPENDOR LOUDSPEAKERS

∙The Spendor SR5 is designed to perform optimally when it is mounted on a wall.

∙It must be fixed securely to a wall or ceiling using the supplied wall bracket.

∙The wall bracket must be securely fixed using the supplied 3 x screws and 3 x wall plugs. The screws must be fixed into a solid wall section. This can be brick, block or, if the wall is dry-lined (e.g. wallboard or plasterboard), a structural timber ‘stud’ or ‘batten’.

∙If the wall is dry-lined and there is no timber batten directly behind the bracket use a suitable expansion fixing (not supplied). Expansion fixings are available from most hardware stores or builders merchants.

∙If the SR5 is mounted very close to a corner or on a ceiling you can place a solid timber batten (spacer) between the bracket and the wall to provide a greater range of adjustment. See figure 4. The spacer can be up to 50mm thick. If a spacer is used, longer fixing screws (not supplied) will be required.

∙For any other installation arrangement seek advice from your Spendor dealer.

∙Install all loudspeaker cables before installing the bracket and allow at least 100mm of free loudspeaker cable directly behind the loudspeaker terminals.

∙Always position the cabinet as close to the wall as possible while allowing a clear gap of at least 2mm between the cabinet rear edge and the wall face.

∙Plan the layout of your room and all loudspeaker positions before installing any cables or brackets.

SR5IM1.DOC

Page 2 of 9