2 BRACKET AND CABINET INSTALLATION

∙Check that all loudspeaker cables have been prepared and installed. See section 3 Cables and Connections.

∙The cabinet is secured to the bracket with 2 x M6 hex-drive socket cap machine screws, 2 x spring washers and 2 x stainless steel bushes. See figure 8. ALWAYS store these components safely whenever they are removed.

∙Remove the two screws and washers using the supplied 5mm hex wrench and carefully detach the bracket from the cabinet.

Figure 8

∙Hold the bracket against the wall (or ceiling) in its final location and carefully mark the centres of the three holes. To ensure a neat installation make sure the bracket is level. See figure 9.

∙Place the bracket to one side.

∙Drill three 5.5mm diameter holes to a clear depth of 30mm. Insert the 3 wall-plugs. Screw the bracket to the wall using the supplied 3 x No 8 cross-head screws. Before tightening the screws check the orientation of the bracket.

Figure 9

∙Check that the 2 x bushes are correctly fitted to the cabinet. Carefully locate the cabinet over the bracket and fit the 2 x M6 screws and 2 x spring washers. Do not tighten the screws completely until all cables have been connected. Tighten the screws securely but do not use excessive force.

∙To adjust the cabinet angle, loosen the M6 screws slightly, adjust the cabinet, then re-tighten the screws.

∙Take care not to mark any wall coverings when using the hex wrench.

SR5IM1.DOC

Page 5 of 9