Assembly Instructions
ASSEMBLY PACK CHECK LIST
■M8x20mm Button Head Socket Screw (4pcs)
■M8x15mm Hex Head Screw (6pcs)
■M8x50mm Button Head Socket Screw (2pcs)
■M8x45mm Button Head Socket Screw (4pcs)
■M4x30mm Self Tapping Screw (4pcs)
■5/16” x 19 x 1.5T Curve Washer (6pcs)
■5/16”x23x1.5T Flat Washer (8pcs)
■M8 Nylon Nut (2pcs)
■13/14mm N Wrench (1pc)
■M5 Allen Wrench (1pc)
■Screwdriver(1pc)
Assembly
■STEP 1
Install the Front and rear stabilizer into the Frame Base Support with 4pcs of M8x45m/m Hex Head Screws and 4pcs of 5/16”x23x1.5T Flat Washers. Then tightly fasten 4pcs of M5x38m/m Self Tapping Screws of the Front and rear Stabilizer Cover by using the 13/14mm N Allen Wrench and Screw Driver.
(As shown in Fig.1~7)
■STEP 2
Connect the Computer Cable (Upper) with Computer Cable (Lower). (As shown in Fig. 8)
■STEP 3
Install the Front Post into the Main Frame with 6pcs of M8x15m/m Hex Head Screws and 6pcs ofψ 5/16”xψ 19 x2T Curve Washers by using the 13/14mm N Allen Wrench . (As shown in Fig. 9)
■STEP 4
Connect the Computer Cable (Upper) with the Hand Pulse Cable. Install the Console with 4pcs of M5x15m/m Button Head Socket Screws by using the Screw Driver.
(As shown in Fig. 10~11)
5 | ZE20 |
|
