Using the Wall Mount Adaptor | Sprint Nextel 1733 manual

USING THE WALL MOUNT

ADAPTOR

1.Position the wall mount bracket on the Base Unit.

Line up the tabs on the wall mount adaptor with the holes on the bottom of the Base Unit . Snap the wall mount bracket firmly in place.

1

2.Mount the Base Unit on the wall. Position the Base Unit so the mounting studs will fit into the holes on the bottom of the Base Unit. Position the power cord to extend down the wall the phone is to be mounted on. Slide the Base Unit down on the mounting studs until it locks into place.

3.Plug in the AC adaptor.

Plug the AC adaptor into an electrical outlet, and the DC connector to the back of the Base Unit. If the Handset battery pack has not been charged previously, place the Handset in the Base Unit cradle, and allow it to charge for 16 hours.

4.Connect the telephone line cord. The telephone line cord has a snap-in plug at each end, Insert one of the plugs into the jack qn the bottom of the Base Unit. Insert the other end of the plug into the wall jack.

Image 15

Sprint Nextel 1733 manual Using the Wall Mount Adaptor

Contents

Spread Spectrum Cordless Telephone Table of Contents Table of Contents O N E Book Page Introduction Special Features Parts Checklist Sprint National Help Desk at FCC Part FCC Part IC Industry Canada Page Sprint National Help Desk at a ITS Impossible to OVER- Charge the Battery Pack To Charge the Battery Pack Desk at Replacingthe Handset Battery Pack Tonupulse Selection Setting UP AC Power AdapterSetting Ringer Pack Beforeuse Using the Wall Mount Adaptor Handset Layout Page From the Handset Making Calls Ringer Control Volume ControlAnswering Calls Temporarytone Redial with the Handset -ON OFF Hook Hold Press PHONE. The Sprint From the Handset when Handset OFF or on HookRedial with the Handset OFF on Hook Intercom Between Handset and Base From the Base when From the Handset when Handset on or OFF HookFrom the Base when Speakerphoneoff Conference Reviewing Caller ID RecordsMemory Dialing Flash RDL Redial MEM Memory Set ToneIPulse Del delete MSG Icon Save DlAL DEL Delete Call Waiting ID Caller ID Call Waiting NEW Phone Book Records Editing Phone Book Records XX location displayedis itsorigi- nal location Adding NEW Phone Book Records R s Page Page Delete MSG Icon Answer OFF To purchase a Headset, call Sprint National Help Desk at OperationBelt Clip Icon. Press Enter Messagewaiting Indicator for use with Voicemail Call is answered Custom PAY-PER-USE PPU Features LOW Battery Indication Check AC Power Indication Avoid Water CLEAN~NGYOUR TelephoneTaking Care of Your Telephone Avoid Roughtreatment Handset does not Ring When YOU Receive a Call Phone Doesntwork AT ALLNo Dial Tone Required Limited Warranty Frequency Control WeightPower Requirements Specifications are TYPI- CAL and MAY Change Without NoticePage