ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
RIGHT |
BRACKET |
LEFT |
STEP 1: Insert the FRONT STABILIZER(2) into the MAIN FRAME(1) and lock in position with the
LOCKING KNOB(31).
NOTE: Pull the FRONT STABILIZER(2) out for use. Push the FRONT STABILIZER(2) in for storage. Adjust the FRONT STABILIZER(2) by loosening the LOCKING KNOB(31), then slide the FRONT STABILIZER(2) to adjust the position. Tighten the LOCKING KNOB(31).
STEP 2
NOTE: The RIGHT PEDAL(6) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(6) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(5) has L stamped on the end of the pedal shaft. The LEFT PEDAL(5) has left hand threads and is tightened by turning counter clockwise.
Thread the RIGHT PEDAL(6) onto the right side of the CRANK(7) as shown. Tighten the pedal securely. Do the same to attach the LEFT PEDAL(5) onto the left side of the CRANK(7).
STEP 3: Install two "AA" batteries into the back of the METER(29). Plug the SENSOR WIRE(28) to the METER(29), then slide the METER(29) onto the Bracket on the MAIN FRAME(1).
6
