ASSEMBLY INSTRUCTIONS

STEP 5

NOTE: Refer to the illustration below. Be careful not to damage the Sensor on the METER(13) when
disassembling or installing the METER(13).
By hand or by using a simple tool remove the METER(13) from the LEFT and RIGHT COVERS(35, 36).
Install an AAA battery into the METER(13), the battery is not included. See page 9 for detailed battery
installation instructions. Press the METER(13) back into the opening between the LEFT and RIGHT
COVERS(35, 36).

STEP 4

NOTE: The RIGHT PEDAL(38) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(38)
has rig ht hand threads and is tightened by turning cl ockwise. T he LEFT PEDAL(37) has L
stamped o n the end of the ped al shaft. The LEFT PEDAL(37) has l eft hand threads and is
tightened by turning counterclockwise.
Thread the RIGHT PEDAL(38) to the right side of the CRANK(5) as shown. Tighten the pedal securely.
The shoulder of the PEDALS(37, 38) should be in contact with the CRANK(5) when securely tightened.
Do the same to attach the LEFT PEDAL(37) to the left side of the CRANK(5).
8
Shoulder
Sensor