Stamina Products 55-1725 owner manual UPRIGHT6

ASSEMBLY INSTRUCTIONS

L
Look down from the top
Pivot Tube
Shaft	R
	Pivot Tube

STEP 7: There is an "L" decal on the LEFT HANDLEBAR(7), and an "R" decal on the RIGHT HANDLEBAR(8). To assemble the RIGHT HANDLEBAR(8), place a SPACER(56) and a LARGE WASHER (M16)(57) onto the right side of the SHAFT on the UPRIGHT(6). Slide the RIGHT HANDLEBAR(8) onto the SHAFT and secure with a LARGE WASHER(M8)(48), LOCK WASHER(M8)(91), and BUTTON HEAD BOLT(M8x1.25x20mm)(66). Repeat on the left side.

STEP 8: Attach the LOWER PIVOTING ARMS(9) to the LEFT and RIGHT HANDLEBARS(7, 8) with HEX BOLTS(M6x1x36mm)(73), ARC WASHERS(M6)(88), LOCK WASHERS(M6)(90), and ACORN NUTS (M6x1)(86). The HEX BOLTS(M6x1x36mm)(73) fit inside the hex-shaped holes in the HANDLEBARS (7, 8). Attach the LOWER PIVOTING ARMS(9) to the LINKAGES(10) at both sides with the PLASTIC WASHERS(M8)(53), BUTTON HEAD BOLTS(M8x1.25x48mm)(67), and NYLOCK NUTS(M8x1.25)(80).

STEP 9: Look down from the top of the UPRIGHT(6) to make sure the pivot tubes on the HANDLEBARS (7, 8) are parallel to the FRONT STABILIZER(2) and the PEDAL ARMS(4, 5) are crossing the ROLLERS(60) properly. Tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(65) as described in STEP 4 on the

UPRIGHT(6).

10