SPECIFICATIONS |
| |
Operating Pressure | ||
Flow Range | ||
Optimum Flow | 8 gpm / 30 lpm | |
Capacity | 1- to | |
Porting | 8 SAE | |
Connect Size and Type | 3/8 in. Male Pipe Hose End | |
System | Open Center, HTMA Type II/ETMA Category D | |
Rotating Speed | ||
Hose Whips | Yes | |
Weight | 45 lb / 20.4 kg | |
Length | 14 in. / 35.6 cm | |
Motor | Integral | |
SOUND POWER AND VIBRATION DECLARATION |
| |
Measured |
| 111 dBA |
Uncertainty, Kwa, in decibels |
| 3 dBA |
Measured | 98 dBA | |
Uncertainty, Kpa, in decibels |
| 3 dBA |
Values determined according to noise test code given in ISO 15744, using the basic standard ISO3744 | ||
NOTE- The sum of a measured noise emision value and its associated uncertainty represents an upper | ||
boundry of the range of values which is likely to occur in measurements. |
| |
Declared vibration emission value in accordance with EN 12096 |
|
|
Measured vibration emmission value: a |
| 25.6 m/sec² |
Uncertainty: K |
| 8.4 m/sec² |
Values determined according to ISO |
|
|
ACCESSORIES |
| |
Carbide Bit 1 in. x 24 in. Long (Drills | 02281 | |
Carbide Bit | 02282 | |
Carbide Bit 2 in. x 24 in. Long (Drills | 02283 | |
Carbide Bit 1 in. x 18 in. Long (Drills | 04668 | |
Carbide Bit | 04896 | |
SERVICE TOOLS |
| |
Tamper Sleeve Tool | 01120 | |
Accumulator Tester | 02835 | |
Flow and Pressure Tester | 04182 | |
04337 | ||
Flow Sleeve Removal Tube | 04910 | |
Flow Sleeve Removal Tool | 04919 | |
Bearing Installation Tool | 05044 | |
Latch Removal Tool | 05045 | |
Bearing Installation Tool | 05061 | |
Latch Installation Tool | 05062 | |
Accumulator Cylinder Puller | 05640 | |
Seal Kit | 05839 | |
Latch Installation Tool | 05879 | |
Accumulator Charge Kit | 06545 |
16