| SPECIFICATIONS |
|
|
Operating Pressure | |||
Flow Range | |||
Optimum Flow |
| 8 gpm / 30 lpm | |
Capacity | 1- to | ||
Porting |
| 8 SAE | |
Connect Size and Type | 3/8 in. Male Pipe Hose End | ||
System | Open Center, HTMA Type II/ETMA Category D | ||
Rotating Speed | |||
Hose Whips |
| Yes | |
Weight |
| 45 lb / 20.4 kg | |
Length |
| 14 in. / 35.6 cm | |
Motor |
| Integral | |
SOUND POWER AND VIBRATION DECLARATION |
| ||
Test conducted on HD45310E, S/N 5606 operated at standard 8 gpm input |
|
| |
Measured |
| 111 dBA | |
Uncertainty, Kwa, in decibels |
|
| 3 dBA |
Measured | 98 dBA | ||
Uncertainty, Kpa, in decibels |
|
| 3 dBA |
Values determined according to noise test code given in ISO 15744, using the basic standard |
| ||
ISO 3744. |
|
|
|
NOTE: The sum of a measured noise emission value and its associated uncertainty represents |
| ||
an upper boundary of the range of values which is likely to occur in measurements. |
| ||
Declared vibration emission value in accordance with EN 12096 |
|
| |
Measured vibration emission value: a |
|
| 25.6 m/sec² |
Uncertainty: K |
|
| 8.4 m/sec² |
Values determined according to ISO |
|
| |
ACCESSORIES |
|
|
|
Carbide Bit 1 in. ⋅ 24 in. Long (Drills | 02281 | ||
Carbide Bit | 02282 | ||
Carbide Bit 2 in. ⋅ 24 in. Long (Drills | 02283 | ||
Carbide Bit 1 in. ⋅ 18 in. Long (Drills | 04668 | ||
Carbide Bit | 04896 | ||
SERVICE TOOLS |
|
|
|
Tamper Sleeve Tool |
| 01120 | |
Accumulator Tester |
| 02835 | |
Flow and Pressure Tester |
| 04182 | |
| 04337 | ||
Flow Sleeve Removal Tube |
| 04910 | |
Flow Sleeve Removal Tool |
| 04919 | |
Bearing Installation Tool |
| 05044 | |
Latch Removal Tool |
| 05045 | |
Bearing Installation Tool |
| 05061 | |
Latch Installation Tool |
| 05062 | |
Accumulator Cylinder Puller |
| 05640 | |
Seal Kit |
| 05839 | |
Latch Installation Tool |
| 05879 | |
Accumulator Charge Kit |
| 31254 | |
16 ► HD45 User Manual |
|
|
|
